Parkside PSZ 250 B2 User Manual download pdf (Page 14)

14 GB/MT

Introduction / Important safety instructions / Safety notices specific to the device

Introduction

Cable winch PSZ 250 B2

Introduction

Please familiarise yourself with the appli-

ance before preparing it for use and using

it for the ﬁrst time. To do so, please care-

fully read the following operating instructions and

the important safety information. Use the product

only as described and for the indicated purpose.

Keep these instructions in a safe place. If you pass

the device on to anyone else, please ensure that

you also pass on all the documentation.

Intended use

The cable hoist is used to hoist and lower loads in

indoor spaces in accordance with the equipment

power. Only use the device as described. Any other

use is not intended. The user / operator, not the ma-

ufacturer, is liable for damages or any type of inju

resulting from any other use. Please note that our de-

vices were not constructed for commercial, manual,

or industrial use. We do not accept any warranty li-

ability if the device is used for commercial, manual,

or industrial operations, or activities similar to these.

Parts description

Mounting bracket

Mounting opening for hook in deﬂection

operation

Hoisting drum

Maximum cable length lever

Auto-stop mechanism lever

Steel cable

Shut-oﬀ weight

Hook

Emergency stop switch

Push button

Remote control unit

Mains lead

Control lead

Motor

Deﬂection pulley

Additional hook

Scope of delivery

1 Cable hoist

2 Mounting bracket with mounting materials (Fig. C)

1 Deﬂection pulley with additional hook and moun-

ting materials (see Fig. D)

1 Set of instructions for use

Technical Data

Voltage: 230 V

50 Hz

Rated current: 2.2 A

Power input: 500 W

Duty type: S3 20 % 10 min

Rated load: 125 / 250 kg (without / with

deﬂection pulley)

Hoisting height: 11.5 / 5.7 m (without / with

deﬂection pulley)

Rated speed: 8 / 4 m / min (without / with

deﬂection pulley)

Steel cable

diameter: 3.0 mm

Steel cable

tensile strength: 1870 N / mm

Insulating level: B

Degree of

protection: IP54

Power unit class: M1

Net weight: 9.3 kg

Gross weight: 10.5 kg

Duty type 3–20 % - 10 min: S3 = Intermittent duty

without the eﬀect of starting. During a 10 min period

the max. operating time is 20 % (2 min).

Mechanical group M1.

The rated power of the device does not vary with

the position of the load.

The value of the A-rated noise emission in the oper

ator

position is less than 70 dB.

The cable hoist must be operated at ambient tempe-

ratures from 0 °C to 40 °C and a relative humidity

below 85 %. Height above sea level: max. 1000 m.

100684_par_Seilhebelzug_content_IT.indd 14 02.07.14 12:41

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Comments to this Manuals

No comments

Parkside PSZ 250 B2 User Manual Page 14

Comments to this Manuals

Related products and manuals for Hoist Parkside PSZ 250 B2