Parkside PFS 710 B1 User Manual download pdf (Page 30)

30 GB

Rotating the hand grip

DANGER OF INJURY! Pull

the mains plug out of the socket before you carry

out any task on the device. The hand grip

can

be rotated by 90° to the right or left. This allows

the ON / OFF switch

to be brought into the most

comfortable position for any working conditions.

Press the unlocking button

and rotate the

hand grip

to the right or left.

Make sure the hand grip

engages.

Adjusting the shoe

DANGER OF INJURY! Pull

the mains plug out of the socket before you carry

out any task on the device.

Adjust the shoe

to suit the cutting depth.

To do this release the shoe adjustment lever

and place the shoe

in appropriate position.

Lock the shoe in this position by pulling the

shoe adjustment lever

tight.

Setting the blade speed

With the oscillation speed setting wheel

you can

chose the desired stroke rate (- = lower stroke rate,

+ = higher stroke rate).

The stroke setting can also be changed during op-

eration.

Preparing for use

Switching on and oﬀ

When operating the device you can select between

intermittent or continuous operation mode.

To switch on intermittent operation mode:

Press the ON / OFF switch

To switch oﬀ intermittent operation mode:

Release the ON / OFF switch

To switch on continuous operation mode:

Press the ON / OFF switch

and ﬁx it in the

pressed position with the lock button

To switch oﬀ continuous operation mode:

Press the ON / OFF switch

and release it

again.

Guiding the sabre saw

safely and accurately

The shoe

pivots to adjust to the workpiece and

provides safe support to the device. It must always

lie against the workpiece when the device is in use.

Advice about ways of

working when sawing

Before sawing, check the workpiece for foreign

bodies such as nails, screws etc. and remove

them.

Do not allow the ventilation slots to become

covered.

Switch the device on ﬁrst and only then bring it

into contact with the workpiece.

If the saw blade jams, switch oﬀ the device im-

mediately.

Open the sawn gap in the workpiece slightly

using a suitable tool and extract the saw blade.

Always make sure the saw blade type and the

blade oscillation speed are suitable for the

workpiece material.

There are diﬀerent saw blades available in var-

ious lengths designed to ensure optimum perfor-

mance of every sawing task with your sabre saw.

Saw the material using a steady forward rate

of progress.

Flush sawing:

Using ﬂexible saw blades of adequate length you

can trim oﬀ projecting workpieces, such as pipes,

directly at the face of a wall.

Before use / Preparing for use Preparing for use / Maintenance and cleaning / Service centre / Warranty

1 2 ... 25 26 27 28 29 30 31 32 33

Comments to this Manuals

No comments

Parkside PFS 710 B1 User Manual Page 30

Comments to this Manuals

Related products and manuals for Power saws Parkside PFS 710 B1