Parkside PMNF 1350 A1 User Manual download pdf (Page 21)

21 GB/MT

General power tool safety warnings / Start-up / OperationGeneral power tool safety warnings

Original accessories / tools

Use only the accessories and attachments de-

tailed in the operating instructions, or those which

are compatible with the device.

Start-up

Setting the groove depth

Loosen set screw

Set the depth stop

to the desired depth.

Tighten set screw

Installing the dust

extraction adapter

Slide the pegs of the extraction adapter

into the slots of the dust extraction connection.

Turn the extraction adapter

to lock.

Loosen union nut

3 a

Insert the tube of the extraction unit far enough

into the opening on the union nut

3 a

Tighten union nut

3 a

Operation

Switching ON / OFF

NOTE: Always switch on the device before bringing

into contact with the material and only then apply

the device to the work piece. The wall grinder fea-

tures electronic smooth start-up. The motor‘s start-up

is delayed.

Switching the unit on:

Activate the switch lock

(see Fig. C). Then

press the ON / OFF switch

Switching the device off:

Release the ON / OFF switch

Installing and adjusting

the cutting width of the

diamond cutting discs

Loosen set screw

Slide the depth stop

up.

Press and hold the spindle lock

Use the face pin wrench

to loosen the

adapter ﬂange

Remove the adapter ﬂange

Set the desired cutting width with the number

of spacers

. Be sure to use the centring

ﬂange

as the top spacer.

NOTE: You may choose from various spacers.

Please note, the total number of spacers betw

een

the cutting discs and the thickness of the cutting

discs yield the groove width.

Tighten the adapter ﬂange with the face pin

wrench

. When doing so, hold the spindle

lock.

NOTE: When setting a cutting width smaller

than the maximum, you must use the spacers

on the clamping collar side, as the clamping

collar alone cannot secure the discs due to the

thread length on the spindle (see. Fig. D).

NOTE: Always replace diamond cutting discs

in pairs.

Handling the wall chaser

(see Fig. E)

ATTENTION! This device is only suitable for

dry cuts!

Use a cable detector to check walls for hidden

electrical-, gas- and water lines before using

the wall chaser.

Select the desired groove width.

Apply the roller

of the device onto the brick

wall.

Now switch on the device and immerse into

the brick wall until the depth stop

touches.

Now cut the groove into the brick wall, noting

the cutting direction. The device must be rotat-

ing in the opposite direction. The device can

otherwise erratically be pushed out of the cut.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 34 35

Comments to this Manuals

No comments

Parkside PMNF 1350 A1 User Manual Page 21

Comments to this Manuals

Related products and manuals for Power saws Parkside PMNF 1350 A1