Parkside PFS 710 User Manual download pdf (Page 8)

mounting hole in the saw blade. The blade must

not pull out.

3. Firmly retighten the Allen screw

Check that the saw blade is ﬁxed safely and

ﬁrmly before taking the appliance into operation.

L

Blade speed setting wheel

With the adjusting wheel

you can pre-select the

desired number of strokes (Number of to and fro

movements) (MIN. = smallest number of movements,

MAX. = largest number of movements).

The blade speed can also be selected whilst you are

using the tool.

L

Setting the oscillation action

With adjustment of the shuttling, using the rotary

switch shuttling

you can match the operation of

the saw blade to the material to be worked on.

Setting 0 (oscillation action is switched off):

This setting is suitable for sawing soft or hard

materials. This setting can also be used to produce

clean-cut edges.

Setting I:

Suitable for materials of medium strength, e.g.

hardwood, plastic.

Setting II:

Use this setting when you are sawing soft materials

such as lightweight building or insulation materials.

Setting III:

Set the rotary switch in this position if you are cut-

ting softwood / pruning trees or soft materials.

L Preparing the saw for use

The mains voltage at the plug must match that shown

on the rating plate on the tool. Equipment shown as

230 V ~ can also be used on 220 V ~ supplies.

L 

Guiding the sabre saw safely

and accurately

The shoe

pivots to adjust to the workpiece and

provides safe support to the tool. It must always be

set against the workpiece when the tool is in use.

Switching On and Off

You can choose between short and permanent

functioning for the operation. For brief work use the

short function setting and for extended work use the

permanent function setting.

Switching on short function operation:

j Press the On / Off switch

Switching off short function operation:

j Release the On / Off switch

Switching on permanent functioning:

j Press the On / Off switch

and hold it in this

position with the retaining button

Switching off permanent functioning:

j Press the On / Off switch

and then release it.

L 

Advice about ways of working

when sawing

JBefore sawing, always check the workpiece for

foreign bodies such as nails, screws etc. and

remove them.

JDo not allow the ventilation slots to become

covered.

JSwitch the tool on and only then bring it into

contact with the workpiece.

JIf the saw blade jams, switch off the tool im-

mediately. Open the sawn split in the workpiece

slightly using a suitable tool and extract the

saw blade.

j Always make sure the saw blade type and the

blade speed and oscillation settings are suitable

for the workpiece.

j Narrow blades are best for tight curves.

Before taking into use / Preparing the saw for use

10 GB/IE

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Parkside PFS 710 User Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Parkside PFS 710