Parkside PDMS A1 User Manual download pdf (Page 30)

27

PDMS A1

GB

Initial operation

NOTE

►

The grinder may only be operated on

cleaned, oil-atomised compressed air and

may not exceed the maximum operating

pressure of 6.3 bar at the appliance. The

compressor must be ﬁ tted with a pressure

reducer to regulate the working pressure.

► Wind the Teﬂ on tape supplied around all

threaded connectors.

♦ Connect the appliance to a suitable compressed

air source.

♦ First screw the 1/4“ threaded nipple onto

the mini compressed air oiler 1/4“ threaded

connector .

♦ Then ﬁ ll the mini compressed air oiler with

1-2 drops of special compressed air oil. To

do this, undo the crosshead screw at the mini

compressed air oiler

oil ﬁ ller opening

and allow a few drops of oil to enter the oil

ﬁ ller opening with the help of the oil bottle

included in delivery.

NOTE

►

A mist oiler continuously and optimally lubri-

cates the grinder as a preparation stage

after the pressure reducer. A mist oiler adds

ﬁ ne drops of oil to air ﬂ owing through the

appliance and therefore guarantees regular

lubrication.

♦ Now screw the 1/4“ threaded nipple onto

the mini compressed air oiler 1/4“ female

threaded connector .

♦ Now press the quick connector on the compressed

air hose (not included in delivery) onto the Com-

pressed air connector plug . The connection

locks automatically.

♦ Now connect the other end of the compressed

air hose to the (ﬁ lter) pressure reducer on the

compressor.

Tool-changing

Always disconnect the grinder from the compressed

air supply before changing tools.

Only ever use tools which are ready for use.

Furthermore, you must ensure that the minimum

clamping length of the shaft in the chuck is not

fallen below.

♦ Using the spanners included in the accessories,

hold the spindle and chuck ﬁ rmly and open

or close the chuck in the direction of the

arrows (see Fig. 3).

Fig. 3

♦ Now insert one of the 10 diﬀ erent whetstones .

NOTE

►

Please note the danger caused by mismatching

the diameter of the grinding tool shaft and

the chuck. Incorrectly-ﬁ xed grinding tools can

cause severe vibration - injury hazard!

♦ Ensure that the grinding tool is correctly ﬁ xed,

and carry out a trial run of 30 seconds in a

safe area at idling speed.

OPEN

CLOSE

IB_43105_PDMSA1_LB1.indb 27IB_43105_PDMSA1_LB1.indb 27 14.05.14 11:1314.05.14 11:13

1 2 ... 25 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments