Parkside PDS 200 A User Manual download pdf (Page 9)

11 GB/IE/CY

Switching on

j Press the ON / OFF switch

9

into the „1“ po-

sition to switch the device on and run it at a

constant speed

Switching off

j Press the ON / OFF switch

9

into the „0“ po-

sition to switch the device oﬀ.

Grinding a workpiece

j Switch on the machine as described above.

j To grind metal tools or metal items, place the

workpiece on the workpiece/tool rest

5

and

slowly bring it up to the grinding wheel

4

.

j Press the workpiece carefully against the grind-

ing wheel

4

. Pressing too hard can overload

the device. When grinding always use the cir-

cumferential end face (not the sides) of the

grinding wheel only (See Figures D, E, F).

Replacing a grinding wheel

Attention! Before carrying out any tasks on the

device itself and when you are not using the de-

vice, always pull the mains plug out of the mains

socket.

J Do not use damaged grinding wheels.

J Only use grinding wheels with details that cor-

respond with those given on the device rating

plate. The circumferential speed should be

equal to or greater than the value given on the

device rating plate.

j Only grinding wheels with markings indicating

the manufacturer, the type of adhesive, dimen-

sions and permitted circumferential speed are

to be used. If you install new grinding wheels

carry out a ringing test before use. Grinding

wheels in good condition give a clear ringing

noise when struck lightly with a plastic hammer.

1) Take oﬀ the outer part of the wheel guard cov-

er

7

by unscrewing the 3 threaded ﬁxings

(see Figs. N, O).

2) Release the nut

13

and then remove the out-

side ﬂange

12

.

3) Now replace the grinding wheel and reassem-

ble all the components in the reverse order.

Take note that the left-hand side of the double

grinding machine has a left-hand thread

11

and the right-hand side has a right-hand

thread. This ensures that the nuts can only be

screwed oﬀ in the direction of rotation of the

spindle.

j Use only the supplied ﬂanges to mount the

grinding wheels.

Note: The grinding wheels are fitted with

a ½“ adapter so that they can be used

with grinding wheels purchased later

with either a ½“, or a 20 mm bore.

Grinding wheels are available in various

grit grades and hardnesses.

The central ﬁxing holes in grinding wheels must not

be redrilled.

Original accessories /

attachments

J Use only the accessories and attachments de-

tailed in the operating instructions. The use of

inserted tools or accessories other than those

recommended in the operating instructions

could lead to you suﬀering an injury.

 Maintenance and cleaning

Attention! Before carrying out any tasks on the

device itself and when you are not using the device,

always pull the mains plug out of the mains socket.

The device is largely maintenance-free.

j Clean the device frequently. For best results,

clean the double grinding machine immediate-

ly after you have ﬁnished using it.

j Do not allow any liquids to enter the device.

Use a dry cloth to clean the device.

j Do not under any circumstances use petrol or

Preparing for ﬁrst use / Maintenance and cleaning

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments