Parkside PABS 14.4 A1 User Manual download pdf (Page 11)

11 GB/IE/CY

General safety advice for electrical power tools / Start-up Start-up / Operation

Torque pre-selection

You can adjust the torque by using torque pre-se-

lection

Select a low setting for small screws, soft work

material.

Select a high setting for large screws, hard

work materials and for the extraction of screws.

For drilling, push the selector to the setting for

drilling, in that you adjust the torque pre-selector

to the position

2 Gear Drive

CAUTION! Move the gear selector switch

only after the device has come to a standstill.

Failure to observe this advice may result in damage

to the device.

In the ﬁrst gear (Gear selector switch

in Position: 1)

A speed of up to approx. 400 rpm can be achieved

and a high torque. This setting is intended for use w

ith

all screwing tasks and for accessories (see example

Fig. B).

In the second gear (Gear selector switch

in Position: 2)

It achieves a speed of up to approx. 1300 rpm, for

the carrying out of drilling tasks (see example Fig. A).

Operation

Switching ON / OFF

Switching on:

To start the appliance squeeze on the ON /

OFF switch

and then keep it pressed down.

The LED working light

comes on with a slightly

or fully pressed ON /OFF switch

and illumi-

nates the working area in poor lighting conditio

ns.

Switching off:

To stop the appliance, release the ON / OFF

switch

Setting the speed

The ON / OFF switch

has a variable speed cont

rol

device. Slight pressure on the ON / OFF switch

will cause the rotation speed to slow down. With in-

creased pressure, the rotational speed will increase.

Note: The integrated engine brake means that the

device will come to a fast standstill.

Switching direction of rotation

To switch the direction of rotation, push the

direction of rotation switch

to either the

right or to the left.

Tips and Tricks

Before you use the appliance, check to see that

he screw or drill bit is properly ﬁtted, i.e. locate

centrally in the chuck.

Screw bits are designated with their dimensions

and their shape. If you are unsure, always try

the particular screw bit out to see whether it sits

in the screw head without any free play.

Torque:

Smaller screws and bits in particular can be

easily damaged if you adjust the appliance with

too high a torque and / or rotation speed.

Hard screwdriving conditions (into metal):

Particularly high torques can occur, for example

with metal screws tightened by socket tool bits.

Select a lower rotation speed.

Soft screwdriving conditions (e.g. into

soft wood):

You should also select a low speed in order not to

damage the wood workpiece surface through con

tact with the metal screw head. Use a countersinker.

When drilling into wood, metal and other

materials, take note of the following advice:

With small diameter drill bits use a high drill

speed. For large diameter drill bits, use a low

drill speed.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Comments to this Manuals

No comments

Parkside PABS 14.4 A1 User Manual Page 11

Comments to this Manuals

Related products and manuals for Tools Parkside PABS 14.4 A1