Parkside PDT 40 C2 User Manual download pdf (Page 25)

25 GB/MT

Preparing the product for use / Operation

Connect the device to a suitable compressed

air source.

1. To do so, press the compressed air hose quick-

release coupling (not included in the scope of

delivery) on the ¼“ threaded nipple

of the

compressed air tacker.

Locking is automatic.

2. Connect the other end of the compressed air

hose to the (ﬁlter) pressure reducer on the com-

pressor.

Loading the magazine

1. Press the magazine lever

and pull the mag-

azine cover back to its stop position.

2. Insert the corresponding fastener (nails, see

Fig. 01 or staples, see Fig. 02) into the maga-

zine

. The tacks must be put on the rail of

the magazine

3. Slide the magazine cover forwards until it locks.

Operation

Load the magazine

of the compressed air

tacker as described in the chapter “Loading the

magazine“.

Use the pressure reducer to set the correct

operating pressure.

Ensure that the permissible operating pressure

of 8 bar at the device is never exceeded.

Operating pressure that is too high does not

provide any performance increase, but only in-

creases compressed air consumption and ac-

celerates wear on the device.

Switch on the compressor.

Allow the compressor to run once long enough

until maximum tank pressure is reached and the

device is switched oﬀ.

Place the compressed air tacker on the workpiece

and press the trigger

NOTE: The compressed air tacker is equipped

with a trigger lock

. The fastener will only

leave

the device when the mouth of the compressed

air tacker is pressed against the workpiece and

the trigger

is actuated.

Check that the fastener has been driven in cor-

responding to the work requirements.

– If the fastener is protruding, increase the air

pressure in 0.5 bar increments.

– If the fastener is too deep, decrease the air

pressure in 0.5 bar increments.

As an alternative, you can accelerate the work

by keeping the trigger

depressed.

Set the compressed air tacker against the work-

piece.

Press the device against the workpiece until the

mouth

touches it. The fastener will leave the

device.

As long as the trigger

is kept depressed, each

time the mouth

touches the workpiece one

fastener will leave the device.

Another alternative is to keep the mouth

pressed against the workpiece.

Each time the trigger

is actuated, a fastener

will leave the device.

NOTE: Fine adjustment with the knurled screw

is possible.

Turn the knurled screw

downwards in order

to drive the fastener more deeply into the work-

piece.

Turn the knurled screw

upwards in order to

drive the fastener less deeply into the workpiece.

Safety of the fastener driving tool / Preparing the product for use

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 36 37

Comments to this Manuals

No comments

Parkside PDT 40 C2 User Manual Page 25

Comments to this Manuals

Related products and manuals for Tools Parkside PDT 40 C2