Parkside PGG 15 A1 User Manual download pdf (Page 14)

14 GB

Operation / Cleaning / Service / WarrantyOperation

Changing the engraving point

RISK OF INJURY! Switch the device oﬀ before

performing any tasks on the device and pull the mains plug out of the

mains socket.

Replace the engraving point

as soon as it becomes too worn

and no longer provides the desired engraving performance. Turn

the engraving point holder

anticlockwise until the engraving

point

is released.

Remove the spring and the plain washer.

Push the plain washer and spring on to a new engraving point

Then insert this and turn the engraving point holder

clockwise

to lock the engraving point in position.

Ensure that the engraving point

is properly ﬁxed in position.

Advice on use

You can use the mini-engraver to produce creative, individual engravings.

For example, you can use it to place identifying marks on your valuables.

You can engrave numbers and letters into metal, glass, wood, plastic,

ceramic, stone and leather. This is done with the help of the supplied

engraving stencils

, see Figs. A and B.

Hold the device at an angle, as you would a pencil.

Your arm should rest on the table.

Using very light pressure, guide the engraving point

over the

workpiece. Find the ideal speed of movement by trial and error on

a piece of waste material.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 95 96

No comments

Parkside PGG 15 A1 User Manual Page 14