Parkside PLS 48 B1 User Manual download pdf (Page 62)

62 GB/MT

Using the product

Solder sponge

CAUTION! The hot soldering tip

must never be placed in

contact with a dry solder sponge

, otherwise the solder sponge

may be damaged.

The solder sponge

is used to clean soldering tips.

Moisten the solder sponge

before you use it.

Soldering

If inhaled, vapours may cause headaches and fatigue as

well as other symptoms.

— The soldering pencil has a rated output of 48 watts and is therefore

ideal for electronics soldering (see Figs. A, B).

— The design of the soldering pencil makes it especially suitable for

use where access is diﬃcult or for ﬁne soldering work.

Clean the soldering tip

on the moist solder sponge

After cleaning the tip

it must be “tinned” (coated with solder).

This is done by melting solder on to the hot soldering tip

Guide the soldering tip

to the intended joint site and heat the joint.

Place the solder (with ﬂux) between the joint site and the tip

to melt it.

Continue to feed further solder until the whole joint has a covering

of solder.

Then quickly remove the soldering tip in order to avoid overheating

the molten solder.

Allow the solder to harden while not subjecting it to vibration or

movement.

Note: The ﬂux is either already contained in the solder or applied

separately.

… / Maintenance and cleaning / Service centre

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 83 84

No comments

Parkside PLS 48 B1 User Manual Page 62