Parkside PMGS 12 B2 User Manual download pdf (Page 51)

51 GB

Operation

mended in the operating instructions could lead

to you suﬀering an injury.

Q

Inserting or replacing

a tool / collet

Press the spindle lock

7

and keep it pressed.

Rotate the clamping nut

5

until the lock

engages.

Loosen the clamping nut

5

with the combina-

tion key

23

.

If a tool is already inserted, remove it.

First insert the tool you wish to use though the

clamping nut

5

before you insert it into the

collet

18

suitable for the tool shaft.

Press the spindle lock

7

and keep it pressed.

Insert the collet

18

into the threaded insert and

tighten the clamping nut

5

on the thread using

the combination key

23

.

Using the Insertion tool with mandrel

13

:

NOTE: Use the screwdriver end of the combi-

nation key

23

to release or tighten the screw of

the mandrels

13

.

Insert the mandrel

13

into the electrical tool as

described.

With the aid of the combination wrench

23

,

unscrew the screw from the mandrel

13

.

Place the insertion tool you wish to have onto

the screw between the two washers.

With the aid of the combination wrench

23

,

tighten the screw on the mandrel

13

.

Q

Switching on and oﬀ /

Setting the speed range

Switching on / Setting the speed range:

Connect the plug

4

to the power supply unit

10

by inserting it into the plug-in device

8

provided

for such purposes (see Fig. C).

Connect the device to the power supply by

inserting the mains plug into the socket.

Press down the ON / OFF switch

2

and then

move it in direction of the rotational speed con-

trol

1

. Then set the rotational speed control to

a position between “5” and “20”.

Switching off:

Set the rotational speed control

1

to position

“5”. Press down the ON / OFF switch

2

and

then move it in direction of the cable.

Q

Advice on working with

materials / Tools / Speed ranges

Use the highest speed when working on steel

or iron with the milling bits

20

.

Use a short trial on a test piece to determine the

optimum rotational speed range for working on

zinc, zinc alloy, aluminium, copper and lead.

Use the low speed range for working on plastics

and low-melting point materials.

Use high speeds on wood.

Use the medium speed range for cleaning,

polishing and buﬃng.

The following information shall be considered as

recommendatory only. Learn by practical experience

which tools and settings are the best for the materi-

als you work with.

Setting the appropriate speed:

Numeral on the

rotational speed

control

1

Material to be

worked on

5

Plastics and low melting

point materials

8

Stone, Ceramics

12

Softwood, metal

16

Hardwood

20

Steel

Examples of appropriate tool selection

Function:

Function Accessory Application

Drilling

HSS drill

12

Drilling wood

Milling Milling bits

20

Various tasks, e.g.

hollowing out,

gouging, shaping,

grooving or slotting

1 2 ... 46 47 48 49 50 51 52 53 54

Comments to this Manuals

No comments