Parkside PNTS 1300 B2 User Manual download pdf (Page 37)

37

GB

ply lead and the extension cable for

damage and ageing. Do not use the

equipment if the cable is damaged or

worn.Danger of electric shock hazard.

• If the power cable for this equipment is

damaged, it must be replaced by the

manufacturer, a customer service agent

of the same or a similarly qualied per-

son in order to prevent hazards.

• Switch the machine off and disconnect

the mains plug:

- when the machine is not in use,

- before the machine is opened up,

- for all maintenance and cleaning

work,

- if the connecting cable is damaged

or tangled up.

• Only use replacement parts and acces-

sories delivered and recommended by

our Service Centre. The use of parts by

other manufacturers immediately ren-

ders the guarantee void.

• Do not use the cable to pull the plug

out of the socket. Protect the cable from

heat, oil, and sharp edges.

• Make sure that the mains voltage cor-

responds with the information on the

rating plate.

• Only plug the appliance into a socket

which is safeguarded by at least 13A.

• The device must be connected to a

mains socket via a residual-current

circuit breaker (RCD) with a rated leak-

age current of not more than 30mA.

The following states how damage

to the appliance and possible in-

jury to people can be avoided:

• Ensure that the machine is correctly

assembled and the lters are in the cor-

rect position.

• Do not use without the lter. This could

damage the machine.

• Only use replacement parts and acces-

sories delivered and recommended by

our Service Centre (see “Replacement

parts/Accessories”). The use of parts

by other manufacturers immediately

renders the guarantee void.

• Only have repairs carried out at our

authorised customer service points.

• Observe the instructions for cleaning

and maintenance of the machine.

• Store the appliance in a dry place and

out of reach of children.

Assembly

Pull out the mains plug.

This will prevent danger of injury

from electric shock.

1. Attach the carrying handle

(2) rmly using the cross-head

screws (2a) supplied.

Ensure that the notches on the

carrying handle go onto the lugs

on the motor head (1) (see small

picture).

2. Attach the feet (7) and secure the

feet using the cross-head screws

(7a) supplied.

3. Insert the lter:

- Foam lter for wet vacuuming

(

15).

- Material lter (

16) for dry

vacuuming

- Paper lter bag for ne dust

(

17)

Never vacuum without a lter!

4. Place the motor housing (1) on

top of the dirt collector (6) and

close it with the clip (9).

The fastening clips must be

hooked into the snap-in points

provided.

5. Connect the vacuum hose (13)

and the accessories.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

Comments to this Manuals

No comments