Parkside PDKS 120 User Manual download pdf (Page 10)

10 GB/IE/CY

Attaching the feet

(see Fig. B)

j Attach the feet

from below through the

mounting holes in the device‘s base plate.

j Place the plain washers and then the nuts on to

the screw threads.

j Tighten the nuts using a size 10 open spanner.

Attaching the dust blow tube

(see Fig. C)

j Screw the dust blow tube

clockwise into the

opening provided for it.

Bringing into use

Take note of the mains voltage. The mains voltage

at the mains socket must match that shown on the

rating plate on the device. Devices marked with

230 V can also be operated at 220 V.

CAUTION! Make sure that the device is

switched oﬀ before you connect it to the mains supply.

J Always switch on the electrical power tool before

moving the workpiece against it. Otherwise

there is the risk of kickback.

Setting up the device:

j Grab the device at the position labelled “Bitte

hier anheben - Please lift here” to position the

device.

Switching on the device:

j Press the green ON button

Switching off the device:

j Press the red OFF button

Setting the stroke rate

j Turn the stroke rate controller

clockwise to

increase the stroke rate.

j Turn the stroke rate controller

anticlockwise

to decrease the stroke rate.

NOTE: Be aware that too high a stroke rate leads

to the saw blade heating up, an increase in wear

of the saw blade and burn marks on the material.

j Select a saw speed suitable for the material

being sawn.

Maximum

speed

Medium

speed

Minimum

speed

Thick woo-

den board

Straight

cut

Normal

fretsaw

work

Thin woo-

den or

plastic

board

Straight

and curved

cuts

Normal

and intrica-

te fretsaw

work

Intricate

fretsaw

work

Tilting the saw table

(see Figs. D, E)

j Unscrew the angle setting screw

j Tilt the saw table

until the desired is

reached.

NOTE: The angle can be read oﬀ the angle

scale

6 a

j Retighten the angle setting screw

Inserting / removing the

saw blade

WARNING!

DANGER OF INJURY!

Pull the mains plug out of the socket before you

carry out any task on the device,

Inserting the saw blade

j Lift up the clamping lever

j Insert the saw blade

through the opening in

the saw table

Ensure that the teeth of the saw blade

point

forwards and downwards.

j Suspend the saw blade

in the bottom

blade mount

j Then hook the top pin of the saw blade

the recess provided for this purpose in the top

saw blade mount

Assembly / Bringing into use

33383_SCROLL SAW_Dekupiersaege_Content_LB6.indd 10 23.07.09 11:29

1 2 ... 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Parkside PDKS 120 User Manual Page 10

Comments to this Manuals

Related products and manuals for Power tools Parkside PDKS 120