Parkside PABK 60 A1 User Manual download pdf (Page 10)

10 GB

Clean dusty surfaces so that the suction cups can grip

well. Otherwise a slight shift in position is possible.

Connecting the airbrush set

Be absolutely certain to disconnect the mains

plug before connecting the airbrush set to the

compressor and release the pressure in the lines

by actuating the vent of the air blow gun

Use the respective screw connection to connect

the spray stylus

with the coiled hose

and

the coiled hose to the airbrush connection

Use the included open-end wrench.

(see Ill. A).

Fasten the paint mixing beaker with connection

lid

to the spray stylus

(see Ill. B).

Insert the mains plug into the mains socket.

Note: For optimal results, professionals connect

an intermediate pressure reducer (not included

with delivery). The pressure reducer can be used

to adjust the compressed air at the spray gun

and optimise it to your needs.

Mixing paints for use

The paints included are water-soluble. In order to

properly apply the paints, add water and stir. As

delivered, the paints are too viscous.

First ﬁll the beaker with your selected paint

colour with water.

Now screw the cover back on the beaker and

shake it.

Now use the pipette

to remove two drops

of the slightly diluted paint paste and add them

to a paint mixing beaker completely ﬁlled with

water (

Shake the beaker. Now your paint has reached

the correct consistency.

Attach the paint mixing glass (

) accord-

ing to Ill. B.

Note: If desired, you can adjust the amount of

water added to inﬂuence the colour intensity

yourself as with a watercolour box. The more

water you add, the „thinner“ the colour.

You can also mix individualised colour tones

from the available colour pastes. Please take

note, there must be no paint clumps remaining

in the paint containers. The consistency should

correspond to that of water.

Note: If the paint used does not cover well, in-

crease the amount of paint in the mixture ratio.

Turning airbrush compressor

on / oﬀ

Turn the airbrush compressor

on by setting the

on / oﬀ switch

to the position “I“ (see Ill. C).

Turn the airbrush compressor

oﬀ by setting

the on / oﬀ switch

in the position “0“ (see

Ill. C).

Note: Full pressure is built up after two seconds.

Regulating the air pressure

Regulate the air pressure by actuating the vent

of the air blow gun

to more or less of an

extent.

ATTENTION! The device has a pressure switch,

which periodically and automatically turns the de-

vice oﬀ if there is excess pressure or if it is not in use.

Shortly before reaching the switch-oﬀ point, the

compressor runs more roughly and vibrates. This

may also be the case when re-started under load.

The performance and functionality are not impaired

by this. This is not a defect, rather, serves to protect

the compressor from overloading.

Regulating the spraying results

Regulate the amount of the paint supplied by

turning the paint nozzle of the spray stylus to

the right or left (see Ill. B).

Using the accessories (see Ill. D)

Air mattress adapter

, ball needle

Use a pipe wrench to unscrew the nozzle

9 a

the air blow gun

Then – depending on what is needed – screw

on the air mattress adapter

or the ball

… / Cleaning and care / Information about warranty and service processing

Preparations for use

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 64 65

Comments to this Manuals

No comments

Parkside PABK 60 A1 User Manual Page 10

Comments to this Manuals

Related products and manuals for Equipment Parkside PABK 60 A1