Parkside KH8888 User Manual download pdf (Page 7)

7 GB/IE/CY

Introduction / General safety advice for electrical power tools

Technical Data

Battery-operated car polisher

PARKSIDE KH8888

Rated voltage: 18 V

Idle speed: n

= 3000 min

-1

Sound pressure level: 60 dB (A)

Buﬃng plate: ø 20 cm

Rechargeable battery pack:

Rated voltage: 18 V

Capacity: 1,5 Ah

Energy content: 27 Wh

Battery charger:

Primary:

Rated voltage: 230 V

50 Hz

Rated power: 60 W

Secondary:

Rated voltage: 18 V

Charging current 2600 mA

Charging time: approx. 60 min

Protection class: II /

Noise and vibration data:

Measured values for noise are determined in accord-

ance with EN 60745. The A-weighted noise level

of the electrical power tool are typically:

Sound pressure level: 60 dB(A)

Sound power level: 71 dB(A)

Uncertainty K: 3 dB

Wear ear protection!

Evaluated acceleration, typical:

Hand / arm vibration a

= 2,6 m / s

Uncertainty K = 1,5 m / s

WARNING!

The vibration level given in these

instructions has been measured in accordance with

a standardised measurement procedure speciﬁed

in EN 60745 and can be used to compare devices.

Diﬀerent uses of the device give rise to diﬀerent vibra-

tion levels and in many cases they may exceed the

values given in these instructions. It is easy to under-

estimate the vibration load if the electrical power

tool is used regularly in particular circumstances.

Note: If you wish to make an accurate assessment

of the vibration loads experienced during a particular

period of working, you should also take into account

the intervening periods of time when the device is

switched oﬀ or is running but is not actually in use.

This can result in a much lower vibration load over

the whole of the period of working.

General safety advice for

electrical power tools

WARNING!

Read all the safety advice

and instructions! Failure to observe the safety

advice and instructions may result in electric shock,

ﬁre and / or serious injury.

KEEP ALL THE SAFETY ADVICE AND INSTRUC-

TIONS IN A SAFE PLACE FOR FUTURE REFER-

ENCE! THE TERM “ELECTRICAL TOOL” USED

IN THE SAFETY ADVICE REFERS TO ELECTRICAL

TOOLS POWERED BY MAINS ELECTRICITY (BY

MEANS OF A MAINS LEAD) AND ELECTRICAL

TOOLS POWERED BY RECHARGEABLE BATTER-

IES (WITHOUT A MAINS LEAD).

Workplace safety

a) Keep your working area clean and

well lit. Untidy or poorly lit working areas

can lead to accidents.

Do not work with the device

in potentially explosive envi-

ronments in which there are

inflammable liquids, gases or dusts.

Electrical power tools create sparks, which can

ignite dusts or fumes.

Keep children and other peo-

ple away while you are op-

erating the electrical tool.

Distractions can cause you to lose control of

the device.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Comments to this Manuals

No comments

Parkside KH8888 User Manual Page 7

Comments to this Manuals

Related products and manuals for Grinding machines Parkside KH8888