Parkside PDEXS 150 A1 User Manual download pdf (Page 36)

36 GB/MT

extraction. To do so, open the hook-and-loop

fastener at the side of the dust bag

Adding oil

To ensure a long service life for the compressed air

orbital sander the unit must always be adequately

ﬁlled with pneumatic oil.

You may ensure this in any of the follow-

ing ways:

Connect a service unit with an oiler to the

compressor.

Install a compressed air oiler in the air line or

to the compressor.

Manually add approx. 3-5 drops of pneumatic

oil to the plug nipple

every 15 operating

minutes.

Initial use

Connecting the compressed

air source

Note: Only operate the compressed air orbital

sander with cleaned, condensate-free compressed

air. Never exceed the unit‘s maximum operating

pressure of 7.5 bar.

Note: The compressed air source must be ﬁtted

with a (ﬁlter) / pressure reducer to allow the air

pressure to be regulated.

Switching on and oﬀ

Note: Always switch on the compressed air orbit-

al sander before bringing it into contact with the

work piece.

Switching on the compressed air orbital

sander:

Press the operating lever

all the way down

(see Fig. C).

Adjust the speed with the speed control

Switching off the compressed air orbital

sander:

Release the control lever

Disconnect the unit from the compressed air

source after ﬁnishing the work.

Note: First disconnect the hose from the

compressed air source (compressor), only then

disconnect the supply hose from the unit. This

will ensure that the compressed air supply hose

does not wave around or recoil in an uncon-

trolled manner.

Working instructions

Wait until the device has come to a standstill

before you put it down.

Sanding surfaces

Switch on the compressed air orbital sander,

place the entire sanding surface on the surface

to be worked and move it across the work

piece with moderate pressure (see Fig. D).

Note: The sanding output and pattern greatly

dependent on the sanding disc selected and

the pressure applied. Only grinding discs that

are in perfect condition will provide good

grinding performance.

Be sure to apply pressure evenly to increase

the life of the sanding discs.

A sanding sheet previously used on metal must

not be used on other materials.

Replacing the backing plate

RISK OF INJURY! Always

disconnect the device from the compressed air

source before you replace the backing plate

Push the open-ended spanner

between the

backing plate

and collar

Release the backing plate

by turning the

plate anticlockwise and holding the open-ended

spanner

still against this movement.

Working … / Cleaning / Information about warranty and service processing

Before Initial Use / Initial use / Working instructions

96905_par_Druckluft_Exzenterschleifer_content_IT_PT.indd 36 30.04.14 15:46

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 50 51

Comments to this Manuals

No comments

Parkside PDEXS 150 A1 User Manual Page 36

Comments to this Manuals

Related products and manuals for Grinding machines Parkside PDEXS 150 A1