Parkside PSFS 250 A1 User Manual download pdf (Page 30)

30 GB

Note: Please use suitable accessories available

from your speciality retailer to cut wall tiles and /

or edit sheets of metal / light metal.

Installing sanding belts

Install the sanding belts

as shown in Figure C.

Setting the working depth

(see Fig. E)

Loosen the wing bolt

Slide the base plate

to the desired working

depth (to cut through completely set approx.

3.2 mm deeper than the material thickness).

The recommended maximum cutting depth for

wood is 13 mm *(only applies to multipurpose

cutter (HSS)

Retighten the wing bolt

Milling direction for edges

Plunge cutting

Insert the bit into the work piece at an angle

of 45°.

Slowly straighten the bit to an angle of 90° to

begin the cut.

Note: The base plate

must be ﬂush with the

material surface.

Pivot handle (see Fig. F)

Note: Turning the grip during the start up opera-

tions is forbidden. Remove the plug from the socket

and make sure that the swivel lock

is engaged.

Pivot to horizontal

Press and hold the bevel stop

Turn the handle counter-clockwise from ver-

tical to horizontal until the bevel stop locks in.

Pivot to vertical

Press and hold the bevel stop

Turn the handle clockwise from horizontal

to vertical until the bevel stop locks in.

Using the rip fence (see Fig. G)

Loosen the wing bolts

on the base plate

and slide the guide bar for the circle- / rip

fence

through the two openings in the bot-

tom of the base plate

, with the rip fence

facing down.

Position the tool the desired distance from the

edge of the work piece. Tighten the wing bolts

to secure the circle- / ripe fence

to the foot

plate

Cutting circles (see Fig. H)

Note: The position of the guide hole depends on the

desired result, either inside or outside of the edge

of the circle: inside for holes, outside for discs. The

radius can be set from ca. 5 to 16 cm.

Operation Operation / Maintenance and Cleaning / Service / Warranty

1 2 ... 25 26 27 28 29 30 31 32 33

Comments to this Manuals

No comments

Parkside PSFS 250 A1 User Manual Page 30

Comments to this Manuals

Related products and manuals for Power saws Parkside PSFS 250 A1