Parkside PWS 230 A1 User Manual download pdf (Page 6)

6 GB

Introduction / General power tool safety warningsIntroduction

Angle grinder PWS 230 A1

Introduction

We congratulate you on the purchase of

your new

device. You have chosen a

high quality product. The

instructions for use are part of the product. They

contain important information concerning safety,

use and disposal. Before using the product, please

familiarise yourself with all of the safety information

and instructions for use. Only use the unit as descri-

bed and for the speciﬁed applications. If you pass

the product on to anyone else, please ensure that

you also pass on all the documentation with it.

Proper use

This tool is suitable for cutting, roughing and brush-

ing metal materials without the use of water. Any

other use or modiﬁcation to the device shall be

considered as improper use and could give rise to

considerable dangers. We will not accept liability

for loss or damage arising from improper use. The

device is not intended for commercial use.

Note: Slots cut in load-bearing walls must comply

with standard DIN 1053 Part 1 or the regulations

applicable in your country.

These instructions and advice must be observed.

Before you start a task, seek the advice of a com-

petent structural engineer, architect, or the relevant

site management staﬀ.

Features and equipment

Hand grip (rotatable)

ON / OFF switch

Safety lock-out

Unlocking button

Carbon brushes cover

Auxiliary handle

Disc guard cover

Clamping lever

Coded projection

Adjuster screw

Spindle lock button

Threaded hole (3 x) for auxiliary handle

Clamping nut (see Fig. F)

Mounting spindle (see Fig. F)

Mounting ﬂange (see Fig. F)

Coded groove (see Fig. F)

Spanner

Roughing / grinding disk*

Cutting disc for metal* (see Fig. E)

* not included

Included items

1 Angle grinder PWS 230 A1

1 Auxiliary handle

1 Disc guard cover

1 Spanner

1 Operating instructions

Technical information

Rated voltage: 230–240 V

50 Hz

Rated power consumption: 2000 W

Rated speed: n 6500 min

-1

Grinding disc: Ø 230 mm

Mounting spindle: M14 / threaded

Protection class: II /

Noise and vibration data:

Measured values for noise are determined in accor-

dance with EN 60745. The A-weighted noise level

of the electrical power tool are typically:

Sound pressure level: 96.8 dB(A)

Sound power level: 107.8 dB(A)

Uncertainty K: 3 dB

Wear ear protection!

Evaluated acceleration, typical:

Hand / arm vibration a

= 10.075 m / s

Uncertainty K = 1.5 m / s

The vibration level speciﬁed in

these instructions was measured in accordance with

an EN 60745 standardised measurement process

1 2 3 4 5 6 7 8 9 10 11 ... 90 91

Comments to this Manuals

No comments

Parkside PWS 230 A1 User Manual Page 6

Comments to this Manuals

Related products and manuals for Tools Parkside PWS 230 A1