Parkside PLBS 30 B2 User Manual download pdf (Page 13)

CAUTION - DANGER OF BURNS! Allow the

soldering iron to cool completely before cleaning. To avoid

damage, do not use aggressive cleaning material, metal brushes

or sharp objects such as knives, etc.

• Clean the device with a soft, slightly damp cloth if required. Ensure that no moisture enters

the device.

• Clean the soldering tips with the help of the cleaning sponge included in the pack

contents.

Cleaning

Troubleshooting

Fault Possible cause Troubleshooting

Soldering iron does not

heat up.

No power supply. Check that the mains supply

(socket) functions correctly.

Ask a competent person for advice

if necessary.

Mains cable or plug

damaged.

Have the mains cable replaced

by the manufacturer or the

manufacturer's representative.

The temperature of the

soldering tip is too low.

Soldering tip is loose. Disconnect the soldering iron from

the mains. Allow the soldering iron

to cool down. Screw the soldering

tip firmly into the tip holder.

The solder does not run

smoothly on the soldering

iron.

The soldering tip is not hot

enough.

Wait until the soldering iron is hot

enough.

Allow the soldering iron to cool

down completely and check

whether the soldering tip is loose.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Parkside PLBS 30 B2 User Manual Page 13