Parkside PMGS 12 B2 User Manual download pdf (Page 13)

13 GB/IE

CAUTION! The tool continues to rotate

after it has been switched off!

Avoid contact with rapidly rotating

drill / grinder components.

Securely support the

workpiece. Use clamps or a vice to grip the

workpiece ﬁrmly. This is much safer than holding

it in your hand.

Never support your-

self by placing your hands near or in

front of the device or the workpiece

surface. A slip can result in injury.

Avoid contact with moving sanding or

grinding tools.

DANGER OF FIRE FROM FLYING

SPARKS! Abrading metal creates

ﬂying sparks. For this reason, always

make sure that nobody is placed in any danger

and that there are no inﬂammable materials

near the working area.

DUST HAZARD! Any

harmful / noxious dusts generated from machin-

ing represent a risk to the health of the person

operating the device and to anyone near the

work area.

Wear a dust mask!

NOXIOUS FUMES!

Ensure that there is adequate ventilation when

machining surfaces containing plastic or cov-

ered with paint, varnish etc.

Do not soak the materials or the sur-

face you are about to work on with

liquids containing solvents.

Avoid abrading paints containing lead

or other substances hazardous to

health.

Do not machine materials containing

asbestos. Asbestos is a known carcinogen.

Do not machine moist materials or

damp surfaces.

NOTE! Do not allow the tool to come to a

standstill by overloading it!

Switch the device off

and allow it to come to a standstill be-

fore you put it down.

Always keep the de

vice

clean, dry and free of oil or grease.

Children or persons who lack the knowledge or

experience to use the device or whose physical,

sensory or intellectual capacities are limited

must never be allowed to use the device without

supervision or instruction by a person responsible

for their safety. Children must never be allowed

to play with the device.

Q

Operation

Never use the device for a purpose

for which it was not intended or with

non-original parts / accessories. The use

of tools or accessories other than those recom-

mended in the operating instructions could lead

to you suﬀering an injury.

Q

Inserting or replacing

a tool / collet

Press the spindle lock

7

and keep it pressed.

Rotate the clamping nut

5

until the lock

engages.

Loosen the clamping nut

5

with the combina-

tion key

23

.

If a tool is already inserted, remove it.

First insert the tool you wish to use though the

clamping nut

5

before you insert it into the

collet

18

suitable for the tool shaft.

Press the spindle lock

7

and keep it pressed.

Insert the collet

18

into the threaded insert and

tighten the clamping nut

5

on the thread using

the combination key

23

.

Using the Insertion tool with mandrel

13

:

NOTE: Use the screwdriver end of the combi-

nation key

23

to release or tighten the screw of

the mandrels

13

.

Insert the mandrel

13

into the electrical tool as

described.

With the aid of the combination wrench

23

,

unscrew the screw from the mandrel

13

.

Place the insertion tool you wish to have onto

the screw between the two washers.

With the aid of the combination wrench

23

,

tighten the screw on the mandrel

13

.

General safety advice for electrical power tools / Operation

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Comments to this Manuals

No comments